Sennheiser CONFERENCE AND INFORMATION SYSTEMS SDC 3000 Specifications download pdf (Page 47)

Turning central units and power supplies on and off

When turning on the conference system, it is important that the

components are turned on in the correct order.

 First turn on the central units. In conference systems with several central

units, first turn on the “master” central unit.

 Then turn on the power supplies.

Turning the central unit on

 Set the POWER switch  to position “ON”.

The conference consoles which are powered via the central unit as well

as the central unit are now ready for operation.

The start display appears on the LC display of the central unit.

The red signal light ring  and the LED  on all connected conference

consoles light up for approx. three seconds, then flash up twice and go

off again. These conference consoles are now ready for operation.

Turning the central unit off

 Set the POWER switch  to position “OFF”.

The conference consoles which were powered via the central unit are

now disconnected from the voltage supply.







Sennheiser SDC 3000 V 3.0

Volume:

   

.... [MENU]

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 125 126

No comments

Sennheiser CONFERENCE AND INFORMATION SYSTEMS SDC 3000 Specifications Page 47