Sennheiser CONFERENCE AND INFORMATION SYSTEMS SDC 3000 Specifications download pdf (Page 74)

Connecting the computers

Connecting the central unit to the PC

The central unit (or, in case of expansion stage 4, the “master” central

unit) is connected to the Central PC via a RS 232 cable.

 Connect the RS 232 connection of the central unit  to a serial

interface of the Central PC.

Note:

After you have installed the program and inserted the dongle into a

free USB port of the Central PC (see “Installing the software” on

page 77), you must specify the COM port of the computer to which the

central unit is connected (see “Specifying the COM port” on page 100).

With most computers, the serial interface corresponds to COM port 1

(or 2).

If you want to use a separate View-PC, you have to connect it to the Central

PC.

 Connect both computers via an Ethernet network.

 Via the configuration program, enter the IP address of the View-PC

(see “Entering the address of the View-PC (optional)” on page 100).

 Via the conference management program, activate the View-PC (see

“The “Program” box” on page 107).

Note:

The use of a separate View-PC is not supported by this software

version. If you want to use a View-PC, please contact Sennheiser

electronic with regard to a software upgrade.



1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 125 126

No comments

Sennheiser CONFERENCE AND INFORMATION SYSTEMS SDC 3000 Specifications Page 74