Sennheiser CONFERENCE AND INFORMATION SYSTEMS SDC 3000 Specifications download pdf (Page 100)

Assigning microphones to the conference console icons

102

Assigning microphones to the conference console icons

If the location plan of your conference is completed, the consoles have

been assigned the names of the participants and the technical details have

been specified, you now have to assign real microphones to the conference

console icons of your location plan.

 First make sure that your Central PC is connected to the central unit

via the serial interface and that all conference consoles are correctly

connected to the central unit.

 Make sure that the number of the COM port is correct (see “Specifying

the COM port” on page 100).

 From the “Editor” menu, select “List Microphones” to open the “List

Microphones” dialog box. Alternatively, press the “F5” key.

 In the “List Microphones” dialog box, click the

button.

The button turns green and “PC-Mode” appears on the central unit’s

display.

 One after another, press the “MIC” key of all conference consoles – but

maintain the order in which the conference consoles are listed in the

“List Microphones” dialog box!

Alternatively, you can click a conference console in the “List

Microphones” dialog box and then press the “MIC” key of the

corresponding conference console.

The LED next to the “MIC” key as well as the red signal light ring on the

microphone light up. In the “List Microphones” dialog box, the three-

digit microphone address appears next to the “Y” in the “Mic” column.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 125 126

No comments

Sennheiser CONFERENCE AND INFORMATION SYSTEMS SDC 3000 Specifications Page 100