Sennheiser CONFERENCE AND INFORMATION SYSTEMS SDC 3000 Specifications download pdf (Page 33)

Selectable conference modes

“Overrun” mode

In “Overrun” mode, the preset speaker limit is very important.

If the preset limit for simultaneously active microphones has been

reached, a participant can immediately take the floor when pressing the

MIC key . The signal light ring  and the LED  of the delegate unit light

up permanently.

If the speaker limit has been reached and the next participant presses the

MIC key  to join in the discussion, the microphone of the first speaker in

the discussion group will be turned off (FIFO First-In-First-Out).

The chairperson has two options to join in a discussion:

1. Via the chairperson channel of the SDC conference system, the

chairperson can join in a discussion without limitations (e.g. limited

speaking time) by simply pressing the MIC key . The chairperson can

then take the floor immediately. If a conference has more than one

chairperson, their chairperson units function like normal delegate

units. If the chairperson using the chairperson channel has finished

speaking and turns off the microphone by pressing the MIC key 

once more, another chairperson can join in the discussion via the

chairperson channel.

2. By pressing the P1 key , the chairperson can interrupt a discussion

any time. When the P1 key is pressed, all active microphone of the

conference consoles are turned off and the chairperson can take the

floor immediately. By pressing the P1 key  once more, the previously

deactivated microphones are turned on again.











1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 125 126

No comments

Sennheiser CONFERENCE AND INFORMATION SYSTEMS SDC 3000 Specifications Page 33